Publicité
ELECTRICAL SAFETY
• The plugs of electrical appliances must be compatible with the socket. Never change the plug.
Do not use adapter plugs with earthed electrical appliances. Original plugs and matching
sockets reduce the risk of electric shock.
• Use the cable only for its intended purpose. Never use the cable to carry, pull or unplug the
electrical appliance. Keep the cable away from heat, oil, sharp edges and moving parts.
Damaged or twisted cables increase the risk of electric shock.
• When operating an electrical appliance outdoors, use an extension cord that is suitable for
outdoor use.
• If operating an electrical appliance in a damp environment is unavoidable, use a residual
current circuit breaker for personal protection purposes.
• Do not use an electric appliance if the switch is defective.
INTENDED USE
The mulled wine warmer is intended for heating or keeping warm liquids, especially mulled wine
and similar drinks. The appliance is not suitable for soups, stews or similar dishes. Under no
circumstances should flammable or explosive liquids be poured into it. This product must only be
used for its intended purpose. The manufacturer accepts no liability for damage caused by
improper use. Any modification to the product may negatively impact safety, cause hazards and
invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product. After unpacking, check the product for damage and make
sure that it is complete. Subsequent complaints cannot be accepted.
FIRST USE
Before using the appliance for the first time, rinse it with hot water and clean the tank, lid and
exterior with a cloth and a simple cleaning agent.
OPERATION
• Place the warmer on a flat, level surface.
• Remove the lid and fill the tank.
IMPORTANT! Never fill beyond the 'MAX' mark.
• Replace the lid and turn it so it locks in place.
• Plug in the power plug.
• To switch on the mulled wine warmer, press the on/off switch so it is set to 'I'.
• Select your preferred temperature using the temperature control dial. The light on the heating
indicator will turn on and the appliance will start the heating process.
• After about 35 minutes (depending on the amount of liquid poured in), the liquid will have
reached 97 °C and the automatic thermostat will maintain the set temperature.
• Hold a glass under the tap and carefully allow the drink to dispense.
• When there are roughly three cups of liquid left, you will either need to switch off the appliance
and disconnect it from the power supply or top up with more liquid.
CAUTION! The remaining liquid is hot; risk of burns!
9
www.DEUBAXXL.de
Publicité
