Publicité
MOUNTING THE CRANK
1
Mount the crank
8
to the hand winch
and fix it with the nut.
CHANGING THE GEARWHEELS
3
Fix the crank
8
to the axis bolt of the
small gearwheel 6:
Less strength required - more rotations
needed.
FIXING A LOAD
1
Unwind the steel cable
2
by rotating the
crank
8
counterclockwise. For this, use
the help of a second person.
Warning! Only pull loads horizon-
tally.
RATCHET SWITCH
1
Unwind: The ratchet switch
3
must be
fully engaged in the shown position.
Unwind by rotating the crank
8
wise.
Warning! Don´t touch the steel ca-
ble without protective gloves!
RELEASE AND REWIND
3
Secure the load at the chosen location.
Afterwards release the steel cable
little to remove the load hook 5.
Warning! lt is possible for the load
to be re leased abruptly!
88
EN
2
Tighten the nut with a spanner.
4
Fix the crank
8
to the axis bolt of the
big gearwheel 7:
More strength required - less rotations
needed.
2
Altach the Ioad hook
5
securely to the
Ioad you intend to pull. Check that the
snap lock
4
is closed.
Warning! Never fully unwind the
steel cable under load.
2
Rewind: The ratchet switch
fully engaged in the shown position.
clock-
Rewind by rotating the crank
terclockwise.
Warning! Never operate the product
without engaged ratchet switch!
4
To rewind, hold the steel cable at the
2
a
load hook and rewind neatly. Ensure
also here that the ratchtet switch is
engaged.
1
3
1
3
must be
1
8
coun-
2
4
2
2
EN
89
Publicité
