Publicité
Q
S
UICK
TART
The LED indicator light is on for the cycle currently
Setting A
Setting B
Setting C
Indicator Lights
Start
Unlock
Stop
Cycle Selection
selected:
This setting is factory preset to 1,500 RPM @ 5 minutes
This setting is factory preset to 2,500 RPM @ 4 minutes
This setting is factory preset to 1,500 RPM @ 4 minutes
Begins running the cycle indicated by the cycle indicator LED light.
The lid must be closed.
Allows access into the rotor chamber by engaging the unlocking
mechanism. Entry is only possible when the rotor is stopped.
Pressing the UNLOCK button during operation will terminate the run
and unlock the lid after the rotor has come to a stop.
The LED light is on for the cycle currently selected. To change the
selected cycle, press the UNLOCK button in succession until the
desired cycle is selected. Two seconds after selection, the button
reverts to its UNLOCK function.
Drucker Diagnostics | +1-814-692-7661 | CustomerService@DruckerDiagnostics.com | 7
Publicité
