Publicité
Disassembly and storage
GB
1. Switch the equipment off, pull out the plug from the mains.
2. Open the pressure line (turn on the spigot or nozzle), let the water drain completely.
3. Drain completely the pump and the boiler.
4. Remove the suction and pressure lines.
5. Store the equipment in a frost proof room (at least 5 °C).
Disposal
Disposal of the equipment
Disposal of the packaging
The packaging consists of cardboard and correspondingly marked plastics that can be recycled.
- Make these materials available for recycling.
Faults and trouble shooting
When something does not work...
Risk of injury!
Improperly performed repairs can lead to the device not functioning safely. This endangers
yourself and your environment.
ATTENTION!
In many cases, small defects can result in malfunction. As a general rule, these faults can be solved by
yourself. Before contacting our technical support, please refer to the following table. This will save you
Fault/Mal-
function
Pump does not
work.
Delivery
rate too low.
Not enough
pressure.
20
Products which are labelled with the adjacent symbol must not be disposed of in household
waste. You must dispose of such old electrical and electronic equipment separately.
Please check with your local authority about the possibilities for correct disposal.
Through separate disposal you send old equipment for recycling or for other forms of re-use.
You will thus help to improve the environment.
Cause
No power supply
Motor overheats due to high liquid
temperature
Motor
overheats
ventilation slots
Circuit breaker trip
Defective motor
Water shortage
Leaks in suction line
Solution
Check cables, plug, socket and fuse.
Remove the cause for overheating (max.
liquid temperature 35°C)
due
to
blocked
Activate the circuit breaker.
Call a qualified electrician if the breaker
trips again.
Call the official service.
Ensure enough water supply.
Seal the suction line, tighten threaded
connections
Publicité
