Publicité
Troubleshooting
Problem
Motor does
No electricity
not start
Defective cable
Defective safety switch/plug
combination
Overheat protection actived
Abnormal
Blade is jammed
noises
Lubrication running out
Loose bolts, nuts or other
securing components
Abnormal
Blades damaged or worn
vibrations
Working depth too large
Poor
Working depth too small
scarification
Worn blades
results
Possible causes
Check mains connection
Check cable, plug in, replace if required, or have it
repaired by a qualified person
Arrange for repair in a specialist workshop
1. Working depth too large, set to the shorter depth
2. Blades blocked, remover the blockage
3. Soil too hard, select correct work depth and
forwards and backwards several times while slowly
down the operation speed.
wait till the motor cool down for around 15 minutes
before rework
Switch off wait till complete stop. Remove the objects
Arrange for repair in a specialist workshop
Tighten all components, contact specialist workshop if
noises prevail
Replace or have it checked by an specialist workshop
Set to correct working depth
Set to correct working depth
Replace or have it checked by an specialist workshop
17
Remedy
Publicité
