Publicité
Troubleshooting
IF THE OVEN FAILS TO OPERATE:
1. Check to ensure that the oven is plugged in securely. If it is not, remove the plug from the outlet, wait 10 seconds,
and plug it in again securely.
2. Check for a blown circuit fuse or a tripped main circuit breaker. If these seem to be operating properly, test the outlet
with another appliance.
3. Check to ensure that the control panel is programmed correctly and the timer is set.
4. Check to ensure that the door is securely closed engaging the door safety lock system. Otherwise, the microwave
energy will not flow into the oven.
IF NONE OF THE ABOVE RECTIFIES THE SITUATION, CONTACT A QUALIFIED TECHNICIAN. DO NOT TRY TO ADJUST
OR REPAIR THE OVEN YOURSELF.
Button Adhesion Protection
In any state, if any button on the control panel is in adhesion for 60 seconds, the program will stop working
immediately, the display will show "FAIL" and the system will beep. If the button is in adhesion all the time, a beep will
sound every one minute. Any button will be invalid at this time. After troubleshooting, press STOP/CANCEL button to
return to standby mode.
Protection
OVERHEATING PROTECTION: When the system enters into super high temperature protection status, the digital display
shows "E03" and continues to beep. After pressing STOP/CANCEL button, the system comes back to normal standby
mode. (except microwave function).
LOW TEMPERATURE PROTECTION: When the system enters into super low temperature protection status, the digital
display shows "E04" and continues to beep. After pressing STOP/CANCEL button, the system comes back to normal
standby mode. (except microwave function).
SENSOR MALFUNCTION PROTECTION: The system enters into protection mode when the system sensor is open
circuited or short circuited. The display shows "E05" or "E06" and continues to beep. After pressing STOP/CANCEL
button, the system comes back to normal standby mode. (except microwave function).
CCD-0008956 Rev: 08-08-24
- 19 -
Publicité
