Publicité
Troubleshooting (cont.)
Symptoms
5.
Water stops flowing from
the spray wand before
you are finished
cleansing.
6. Deodorizer feature is not
working.
7. UV sterilization feature is
not working.
8. The toilet does not flush
automatically.
9. The night light does not
turn on in low light
conditions.
Remote Control
Symptoms
The remote control is not
1.
turning on.
2.
The remote control is not
connecting with the toilet.
FCC, IC, CE, and NOM Compliance
FCC ID: N82-KOHLER015, N82-KOHLER016
IFT: Certification Number RCPKO1215-2233 and RCPKO1215-2234.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
1226974-5-B
Probable Causes
A. Five minutes after pressing one
of the spray icons, washing
automatically stops.
A. The deodorizer is not activated.
A. The UV sterilization is not
activated.
A. Automatic flush feature is not
enabled.
A. Night light is not enabled.
B. Low light sensor is not working
properly.
Probable Causes
A. The batteries are not correctly
installed.
B. The batteries are drained.
A. The remote is too far from the
toilet to receive signal.
16
Recommended Action
A. Press the "Rear" or "Front" icon
again.
A. Activate the deodorizer feature
using the remote control.
A. Activate the UV sterilization
feature using the remote control.
A1. Activate the automatic flush feature
using the remote control.
A2. The sensor did not detect the user.
If this issue occurs repeatedly, call
the Customer Care Center using
the information provided on the
back page of this manual.
A. Enable the night light feature using
the remote control.
B1. Clean the light sensor located on
the manual control panel.
B2. Call the Customer Care Center
using the information provided on
the back page of this manual.
Recommended Action
A. Remove and reinstall the batteries.
B1. Replace the batteries.
B2. Call the Customer Care Center
using the information provided on
the back page of this manual.
A. Move the remote closer to the toilet
to regain connection.
Kohler Co.
Publicité
