Maintenance; Repairs - SKY PARAGLIDERS SKY DRIVE II Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

How to mount the system
The SKY DRIVE II can be mounted in two ways:
1. Inside the harness (according to the instructions of the harness
manufacturer).
2. Outside the harness in the supplied outer container.
The safety system should be used only in the configurations described above.

MAINTENANCE

The canopy should be stored in a clean, dry place. Avoid unnecessary
exposure to direct sunlight. If the system gets wet, immediately dry the
canopy and the lines to prevent damage caused by mould. Contamination
by oils, or other chemicals could significantly reduce the load stability of
the life-saving system. A contaminated reserve system should be inspected
by the manufacturer. The outer container can be cleaned (WITHOUT the
canopy inside!) using water and a mild detergent followed by a thorough
rinse and drying. Use only clean water without soap to clean the canopy
and lines.

REPAIRS

All repairs must be carried out by the manufacturer.
Any unqualified repair might lead to failure of the system.
35
35

Publicité

Table des Matières
loading

Table des Matières