Using Sky Drive Ii; Technical Data; Packing - SKY PARAGLIDERS SKY DRIVE II Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USING SKY DRIVE II

Before each flight, check all straps securing the outer container to the harness
(where applicable). Ensure that the container is closed properly, and visually
inspect the safety pins for damage and make sure that they are secure.
Deploying the Reserve Canopy:
1. Find the deployment handle.
2. Grasp the deployment handle. Pull it out of the outer container or
harness.
3. Using the deployment handle, throw the inner container forcefully into
open air (AWAY from the paraglider canopy).
4. Throwing the inner container away will separate it from the canopy.
5. The canopy inflates quickly and easily.
6. You should neutralize your glider and if your are not twisted, the steering
handles on the risers will enable you to direct your reserve.
WARNING!
The reserve must not be used for skydiving! According to EN 12491,
the reserve is not suitable for usage at speeds above 32 m/s (115 km/h)
This guide conforms to requirements specified by Regulation EN 12491.

TECHNICAL DATA

SKY DRIVE II
Surface area (m
)
38
2
Weight of the rescue parachute (kg)
1,85
Max. take-off load (kg)
135
Number of panels
16 (2 x 8)
Max. speed during deployment (km / h)
115
Packing intervals SHV/FSVL (months)
4
Packing intervals LTF (months)
12
Elastics to be used
20 x 2 x 1.5
for repacking (mm)
Certification
EN 12491: 2001 / LTF

PACKING

SKY emergency parachutes have been specially conceived to facilitate all stages
of packing. The following MANUAL is aimed at pilots who are competent in
packing Rogallo parachutes. The manual itself cannot serve as a substitute for
proper training in parachute packing.
The safety and reliability of the system can only be guaranteed if it has been
packed by a trained professional following the correct packing process.
23
23

Publicité

Table des Matières
loading

Table des Matières