Publicité
TDTR 300/500/750/1000EW
6.2
Selecting the operating mode
Mode
Press the
key to switch between the operating
modes:
Auto
Comfort
ECO
Frost protection
6.3
Setting the Comfort temperature
+
Press the key
or
sired target temperature.
In Comfort mode, the temperature can be adjusted
based on use by means of the energy efficiency indi-
cator.
6.4
Setting the ECO temperature
Mode
Press the
key again until ECO is displayed. Press
+
the key
or
briefly to display the ECO set
temperature.
Mode
Press the
key for 3 s, until the ECO temperature
flashes. Confirm the desired temperature with
Mode
and confirm with
ECO operation is recommended for maximum sav-
ings during a short absence (less than 12 hours).
The maximum settable ECO temperature is 19.0 °C.
NOTE
In the factory settings, the ECO temperature is 3.7 °C
below the comfort temperature.
6.5
Automatic operation
Mode
Press the
key again until AUTO is displayed.
Mode for planning the heating times and heating
temperatures:
Programming of Comfort and ECO temperatures,
window monitoring.
Factory setting: Preferred temperature 19 °C, window
monitoring activated.
For
programming
see
Chap. 6.11.
6.6
Frost protection mode
Mode
Press the
key again until
operation is displayed.
For maximum energy savings during a long absence
(longer than 24 hours). The room temperature is main-
tained at around 7 °C.
www.dimplex.de
AUTO
to increase or reduce the de-
.
"Internal
programming",
for frost protection
6.7
Boost function
With the "Boost" function, the maximum heat output
of the device is activated for an adjustable time.
Boost
Press the
put of the device and then set the desired duration
(between 5 minutes and 2 hours) with the keys
.
Then optionally press the
set duration as the standard duration.
6.8
Repeat function
With the "Repeat" function, save up to 2 times at
which the bathroom preheating should start automat-
ically every day so that the bathroom is at the correct
temperature when used.
Saving a time at which the heating process should
start:
Press the
The time in the display flashes twice and the LED
lights up if the save process was successful.
The heating process is started for 15 min regard-
less of the other settings.
To save a second time, repeat the process at the
+
or
desired time.
The LED
cessful.
Reading out and delete the saved times:
Press the
The saved time appears in the display, LED
lights up.
Press the
peat 2-time.
To delete the time, press the
corresponding LED extinguishes.
If no time is saved, no LED lights up and NON appears
on the display for 1 s before returning to the initial
state.
6.9
Window monitoring
The "Window monitoring" function switches the heat-
ing element off automatically if a sudden temperature
drop is identified in the room (e.g. if a window or door
is open). The symbol
Pressing any key automatically starts the heating pro-
cess again.
To activate or deactivate the "Window monitoring"
function, see Chap. 6.12 on page 11.
2409/A
key to activate the maximum heat out-
key for 3 s to save the
Mode
key at the desired time for 3 s.
lights up if the save process was suc-
key.
key again to display the saved Re-
key for 3 s. The
appears on the display.
English
+
or
EN-8
Publicité
