Publicité
English
2 Installation
Outside the
protection zones
Protec-
tion
zone 2
60 cm
The device can be installed in protection zone 2 or
outside of protection zones.
ACHTUNG!
CAUTION!
Do not install the device directly below a wall socket!
ACHTUNG!
CAUTION!
The device may only be attached using the wall
bracket intended for this purpose. It is not permissible
to use adhesives or similar products for attaching the
wall bracket or the device.
2.1
Minimum clearances
150
MIN
The minimum clearances must be observed.
In addition, a clearance of 1 m is to be maintained in
front of the device.
The supply connection socket must be accessible
after installation.
Make sure that the inflow and outflow of air at the top
and bottom of the device are unimpeded.
EN-3
Protection
zone 1
Protection zone 0
60 cm
150
MIN
The heating device must be aligned horizontally and
installed on a vertical wall (see illustration).
2.2
Wall mounting
CAUTION!
ACHTUNG!
The original wall bracket supplied on the rear of the
device must be used.
NOTE
Look out for electric cables or pipework in the wall
when drilling.
2409/A
TDTR 300/500/750/1000EW
www.dimplex.de
Publicité
