Publicité
English
4.2
Key functions
On/Off key
Switching the device on or off.
Plus/Minus key
Raise and lower the target temperature
Mode key
Switch between the different mode operations of the
device.
Boost key
Activate the Boost function for maximum heat output
of the device.
Repeat key
Save two times to which the bathroom should be pre-
heated daily.
4.3
Display
Shows the current settings. The display lights up for
approx. 10 seconds (factory setting) when a key is op-
erated.
The time is displayed automatically after 10 seconds.
Display for heating operation "on"
During heating operation, the
When the specified temperature is reached, the sym-
bol disappears.
Energy efficiency indicator
The
indicator informs the user of the energy con-
sumption based on the configured room temperature.
Arrow on green: low energy consumption
Arrow on red: high energy consumption
For particularly energy efficient operation, it is recom-
mended to run a weekly program and to set the room
temperature at max. 19 °C.
Window monitoring
Interruption of heating operation when window is
open.
Heating program display
Shows the current heating program of the device:
P1-P3: pre-defined programs
P4-P5: user-defined programs
Display LED Repeat 1 and 2
LED lights up if a time has been saved for the Repeat
function
EN-7
symbol appears.
2409/A
5 Initial commissioning
Supply voltage to the device. The display will show
.
Press the
key to switch on the device.
For this display, input the time in the
format HH:MM. The flashing value can
be changed.
Hour display: Select the hour with
the
with the
Minute display: Select the minute
with the
with the
With this display, select the weekday
using the buttons
firm with the
The weekdays are shown on the dis-
play as follows:
LU
MA
ME
JE
VE
SA
DI
NOTE
An extended interruption in the power supply can re-
sult in an incorrect time display. In this case, it will
have to be reset.
6 Operation
6.1
Switching the device on/off
Press the
key to switch on the device. The display
shows the comfort temperature (19 °C) first, followed
by the time after 10 seconds.
The heating indicator
heating up. As soon as the desired temperature has
stabilised, it switches itself on or off, depending on
heating requirements.
Press the
key again to switch off the device. The
display shows ----, followed by the time after 10 sec-
onds.
Any settings that have been configured will remain
applied even if the power supply is interrupted.
TDTR 300/500/750/1000EW
+
buttons
or
and confirm
Mode
key.
+
buttons
or
and confirm
Mode
key.
+
or
and con-
Mode
key.
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
shows that the device is
www.dimplex.de
Publicité
