Publicité
Insert the four roof connector poles
(1) and connect these to the roof
cross connector (8). Please make
sure that the locking mechanisms
(2a) click into place both visibly and
audibly in the holes in the corner
connector (Fig. C).
Warning! Risk of trapping
hands or fingers!
Step 3
Insert the top corner poles (4) into
the corner connector (Fig. D).
Step 4
Pull the pavilion roof (6) over the
frame. Fix the roof into place using
the pre-installed velcro fasteners
(6a) on the roof frame (Fig. E).
Step 5
Insert the bottom corner poles (5)
into the top corner poles and the
bases (9). Fasten the roof loops
(6b) into one of the drilled holes in
the bottom corner pole (Fig. F).
Step 6
Anchor each base with the tent pegs
(10). Use the apertures in the bases
for this purpose.
Knot the end of a guy rope (11) to
each loop (6b) at the outside corner
points of the article. Stretch the guy
ropes out to their full length in order
to achieve a high degree of stability
and fix each end with a tent peg
(Fig. G).
10
GB/IE/NI
Warning! Make sure that the
tent pegs provide a firm hold.
Disassembly
Step 1
Loosen the tent pegs holding the guy
ropes and bases.
Step 2
Release the roof loops from the bot-
tom corner poles. Remove the bases
and bottom corner poles.
Step 3
Remove the roof and top corner
poles.
Step 4
Disassemble the roof frame.
Press on the locking mechanism to
release the poles from the corner
connectors.
Warning! Risk of trapping
hands or fingers!
Step 5
Make sure that the article is clean
and dry prior to storage.
Cleaning and care
Care instructions
Clean the article using a damp cloth
and a mild detergent.
Do not use petrol, solvents or strong
detergents.
Publicité
