Publicité
2、Place the appliance on a stable and level ground, remove the fuel cap and fill the fuel tank with fuel
filter installed. Do not overfill your heater, see the full level position as shown in under figure；
3、Check if there is water or waste in the fuel tank, clean the tank if it is dirty；
4、Fill kerosene or diesel in fuel tank with oil pump only when the fuel filter is proper installed, after the
filling turn the cap clockwise and tighten it.
Figure (fill the fuel tank)
◆ When there is some fuel (kerosene or diesel) in the tank
Attention
1、 Only check the appliance after flameout and removal of the power plug from power source；
2、 Before the ignition make sure there is no oil leakage, when oil leaks please don't use the
appliance and contact your dealer；
3、please check the fuel tank interior, clean the tank if there is water and waste in the tank.
6.INSTRUCTIONS FOR USE
Warning by ignition：
1、 check the fuel tank and make sure there is enough fuel in it；
2、 do not close your face near the heating part after the ignition, keep the safe distance, min. 3 meter
front from hot air outlet，top 2 meter, left and right side more than 2 meter.（see under figure）
3、 stop using the appliance when there is smoke or strange odor omitted；
4、 make sure the heater is ignited before you leave it.
Safety clearances
48
Publicité
