Publicité
BLOWING OPERATION
WARNING
Always wear safety goggles complying with
ANSI Z87.1 (or in Canada CSA Z94.3) when
using as a blower.
WARNING
To avoid injury to bystanders, keep them
clear of blowing debris.
CAUTION
Wear a dust mask if impeller dust which
might be inhaled.
CAUTION
To reduce the risk of hearing loss, wear
ear protectors when using the vac/blower
for extended hours or when using it in a
noisy area.
The vac contains a blowing feature. It has
the capability to blow sawdust and other
debris. It can be used to blow dust and
debris out of garages or off patios and
driveways. Follow the steps below to use
the vac as a blower.
1. Locate blowing port on the vac.
2. Insert one end of the 1-7/8 in. x 7 ft.
hose into the blowing port.
3. Turn vac "ON".
CARE AND MAINTENANCE
FILTER REPLACEMENT
WARNING
To reduce the risk of injury from accidental
starting, unplug power cord before changing or
cleaning the filter. The filter should be cleaned
often to maintain peak vac performance.
WARNING
Do not remove filter cage and float. The float
prevents water from entering the impeller and
damaging the motor. The cage prevents fingers
from touching the moving impeller.
IMPORTANT:
To avoid damage to the impeller and motor,
always reinstall the Clean Connect™ filter before
using the vac for dry pickups and wet pickups.
IMPORTANT:
After cleaning, check the filter for tears or small
holes. Do not use a filter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the filter on the vac, clean the
area of the lid so that the filter will seal against
the lid and stop small particles from bypassing
the filter bag. If the filter is clean and not
damaged, replace it on the filter cage.
If it cannot be reused, place a new filter over
the filter cage.
NOTICE:
Clean the filter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING
To keep the wet/dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe with dry cloth.
STORAGE
Before storing the vac, the dust tank should be
emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in accessory bag
so they can be readily available. The vac should
be stored indoors.
7
ENGLISH
Publicité
