Publicité
1
2
a
Take the trolley frame and
Attach the wheels (b) at
accessoires out of the box. Please
the two sides of the axle (a)
make sure that the trolley frame
respectively.
is placed on a dry, flat and stable
surface. Let the wheel axle (a) pass
through two holes which are at
the end side of the tube.
6
7
f
e
G2
e
f
After standing up the trolley frame,
Firstly, remove the screw from
you MuST set the safety locking unit
the trolley tube. Then install the
(f ) immediately. This safety locking
stand tube (G1) onto the trolley
unit is with self-locking feature. Press
tube. and install the stand
the spring (e) and hook the bent
hook(f ) on the extension part (e).
tube (G2) onto the trolley tube.
Then stop pressing the spring and
There is a positioning hole (IV)
it will retract to lock the safety hook
on the stand tube (G2), it will
unit automatically.
attention: Make sure the safety
attach G1 and G2 to each other
hook unit is locKeD during
by screws. Tight the stand tube
cooking or moving. Do NoT try to
(G1 and G2) and trolley with
turn or pull the safety hook while
screws and nuts.
using this appliance.
3
c
b
There are two mounting holes
on each end side of the axis (a),
insert the "R" pin(c) through the
hole. This will lock the wheels.
8
G1
g
IV
Place the bowl-shaped base of
the appliance (h) into the stand
tube (g).
Fix the bottom of the base
into the positioning hole (IV).
When removing the base from
the stand tube (g), please step
slightly on the supporting tube,
hold the handles of the base
and take it off.
4
b
c
a
Press the wheel covers (d) to
the wheels (b) according to the
three location tips.
9
h
Q
IV
Install the hood. Hold the
hood handle (p) and insert the
clips(O) into the installation
holes (Q) of the base. When
removing the hood, please
open the hood and tilt to 45°
between hood and grill plate,
and detach the clips(o) from
installation holes (Q).
Barbecue-grill
5
II
III
d
I
y
Put the trolley in the
upward position: First,
step on the middle of the
supporting tube (I) with your
right foot, lift up the side
table (II) with your right hand
while lifting the tube for the
wheel (III) upward with your
left hand. Then connect the
p
tube (III) with the tube which
is located under the side
table. The trolley frame is
o
standing up now.
Fold up the trolley: First,
step on the middle of
supporting tube (I) with your
right foot, hold up the side
table (II) with your right hand
whilst your left hand holds
the short edge of support
tube (III) and place it down
slowly.
attention: when folding
up the trolley , Do not hold
the two sides of tube (III) to
avoid that your hand got
pinched.
eN
5
Publicité
