Publicité
Installing the door handle(Optional)
Parts included with the handle kit:
Handle assembly
You will need: A Phillips screwdriver and the included Allen wrench.
1. Insert the two Phillips-head screws into the refrigerator door on the side you
prefer, then tighten.
2. Align the door handle with the screws.
3. Insert the two Allen-head screws through the side of the door handle and
tighten with the Allen wrench.
4. Place the screw caps on the screws.
EN
ATTENTION
The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor.
Installing an optional ice maker
The refrigerator comes set up for ice maker installation, This refrigerator is
compatible with Midea IM1900MD ice maker. Please refer to individual ice maker
installation instruction manual.
• WARNING: Connect to potable water supply only.
• Minimum/Maximum inlet water pressure: 138/827 kPa (20/120 psig).
Screws (4)
Allen wrench
10
Allen wrench
Allen wrench
caps (4)
screws (4)
Publicité
