HEIDENHAIN TNC7 basic Manuel Utilisateur page 82

3
3.3 Programmer et simuler une pièce
3.3.1 Exemple 1339889
ax_t1
Text:
RoHS
Maße in mm / Dimensions in mm
Werkstückkanten nach ISO 13715
Workpiece edges ISO 13715
The reproduction, distribution and utilization of this document as well as the communication of its contents to others without express authorization is prohibited.
Offenders will be held liable for the payment of damages. All rights reserved in the event of the grant of a patent, utility model or design. ( ISO 16016 )
DR. JOHANNES HEIDENHAIN GmbH
83301 Traunreut, Germany
82
W
5
95
100
Original drawing
Scale Format
1:1 A4
Allgemeintoleranzen ISO 2768-mH
General tolerances ISO 2768-mH
-0.3 +0.3
Created
M-TS
11.01.2021
Premiers pas | Programmer et simuler une pièce
10
20
Platte
Plate
Einzelteilzeichnung / Component Drawing
6mm: 0,2 Tolerierung nach ISO 8015
6mm: 0,2 Tolerances as per ISO 8015
Oberflächenbehandlung:
Surface treatment:
Responsible Released
HEIDENHAIN | TNC7 basic | Manuel utilisateur Programmation et test | 10/2023
5
20
ID number
Change No.
Phase:
Werkstoff:
Material:
blanke Flächen/Blank surfaces
Oberflächen nach ISO 1302
Surfaces as per ISO 1302
Version Revision Sheet
- - -
D 1339889 00 A 01
Document number
C000941-05
Nicht-Serie
Page
1
of
1