Publicité
Assembly Steps
IMPORTANT SUPPLEMENT TO INSTRUCTION MANUAL
After assembling any wheel to the axles, maintain a small gap
between the screw thread and the wheel (refer to picture).
If the gap is too big, add two or three washers inside the wheel.
After tightening the nut outside the wheel, turn the wheel by your
finger to check if the wheel can run smoothly. This is very
important, because if the wheel turns smoothly, it is ok. If the nut is
over tightened and prevents the wheel from rolling freely it may
cause damage to the motor. Reduce the number of washers until
the wheel turns freely.
Publicité
