Publicité
Fill Valve Replacement Procedure (continued)
NOTE: Do not overtighten. These are plastic parts. Never use pipe dope on any
water supply connection.
8)
pipe.
9) Turn water supply ON and check for leaks outside the tank.
NOTE:
Once the water stops filling the tank, some residual drops of water may drip
Depending on the manufacturing plant, you may have one of two of the following fill
valves:
For Type A Fill Valve:
Refer to the water level (WL) setting marked
on the inner wall of the tank. Allow the wa-
clockwise in the (+) direction to increase the
water level height (see Illustration 1). Turn
the adjustment screw counter-clockwise in
the (-) direction to decrease the water level
height. Flush the toilet to verify the correct
water level. Adjust as necessary.
For Type B Fill Valve:
There are no water level adjustments. The
fill valve has been preset at the factory.
MAINTENANCE INSTRUCTIONS
w
Water Level Adjustment
Type A
drops will subside.
Type B
Water Level
Ill. 1
6
.
e
Type C
Water
Level
Top of
Tube
Publicité
