2- Unit Description
Menu :
Button:
1. MENU
2. UP
3. DOWN
4. ENTER
5. Signal indicator light of DMX
If the DMX signal was detected, the indicator light flashing.
6. Signal indicator light of slave. If the slave signal was detected, the
indicator light flashing.
7. Signal indicator light of master. If the program in auto or sound mode,
the indicator light is turned on.
8. Signal indicator light of sound. If the signal of sound was detected, the
indicator light was turned on.
Note:(1) In about 10 seconds, if no buttons were pressed, the LED display will be off.
Press any button to turn the display on again.
(2) After pressing a button, all the parameters will be saved after about 2
seconds.
(3) No matter what the program in which mode, once to detect the DMX or
SLAVE signal, the program will jump into DMX or SLAVE mode automatically.
Then, if DMX/SLAVE signal was disconnected, the program will return to the
original mode.
To select the program function
Increase parameter
Reduce parameter
Enter submenu
11