Publicité
USING YOUR AIR CONDITIONER
Appearance may vary.
Turning the Air Conditioner ON or OFF
Press POWER to turn the air conditoner on or off.
IMPORTANT:
If you turn off the air conditioner, wait at least
■
3 minutes before turning it back on. This prevents
the air conditioner from blowing a fuse or tripping a
circuit breaker.
The recommended operating temperature range is between
■
44°F (7°C) and 95°F (35°C). Operating the air conditioner
above or below this range may cause the inside evaporator
coil to freeze up, and the air conditioner will not operate
properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Display
During normal operation, the display
will show the current room
temperature and the mode and
settings. When the UP or DOWN
button is pressed, the unit will display
the set temperature or delay time.
Selecting the Mode
The Mode button has four settings:
Cool
■
Dehumidify
■
Fan
■
Heat (Only for model AMAP14HAW)
■
Press the MODE button until the indicator light below the desired
setting is lit.
Cooling (COOL) Mode
During Cooling mode, the air conditioner cools air from
the room and vents hot air to the outdoors through
the vent hose(s). Adjust fan speed and the temperature setting to
fit your desired comfort level. The temperature setting range is
60°F – 86°F (16°C – 30°C).
IMPORTANT: The vent hose(s) must exhaust to the outdoors
when using Cooling mode.
10
Heating (HEAT) Mode（Only for model
AMAP14HAW）
, the air conditioner blows hot
air to the room and vents cool air to the outdoors
through the vent hose(s). Adjust fan speed and the temperature
setting to fit your desired comfort level. The temperature
setting range is 60 °F – 8 6°F (16°C – 30°C).
IMPORTANT: The vent hose(s) must exhaust to the outdoors
when using Heating mode.
Dehumidify (Dry) Mode
without being in full cooling mode. The fan speed is set
automatically to LOW and cannot be adjusted.
IMPORTANT: For best results, the continuous drain hose should
be connected.
Fan (FAN) Mode
In this mode, only the fan will run. Air is circulated through the
room with no cooling.
NOTE: The air conditioner does not need to be vented to the
outdoors in Fan mode.
Selecting the Fan Speed
The Fan has 3 speed settings:
Low
Medium
High
Press the FAN button until the desired setting is selected.
Adjusting the Temperature
Press the UP or DOWN buttons to
adjust the set temperature up or down
in 1° increments. The temperature setting
range is 60°F – 86°F (16°C – 30°C). After
10 seconds, the display will return to the current room
temperature.
NOTE: Temperature may only be adjusted in Cooling mode.
When in TIMER mode, pressing the UP or DOWN buttons will
adjust the delay time for the air conditioner to shut off or turn
on.
Publicité
