Publicité
Infinite WaterColors
Jandy
®
1.
Turn off power to the Infinite WaterColors LED Light Controller
at the breaker panel.
2.
Loosen the 6 screws on the back of the spa light,
see Figure 4.
3.
Separate the rear spa light assembly housing from the spa light
lens assembly, see Figure 4.
Figure 4.
Separate the Spa Light
4.
Unplug the two blue connector terminals, see Figure 5.
5.
Remove nut from green ground wire, see Figure 5.
6.
Remove nut from PCBA, see Figure 5.
7.
Remove the old PCBA from spa light housing, see Figure 5
Pool & Spa LED Lights | Spare Parts Installation Manual
™
Page 9
Publicité
