Infinite WaterColors
Jandy
®
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION. This underwater light
must be installed and repaired by a licensed or certified electrician in accordance
with the National Electrical Code® and applicable local codes and ordinances.
In Canada, the Canadian Electrical Code and all applicable local codes and
ordinances must be adhered to. Improper installation and/or repair will create
an electrical hazard, which may result in death or serious injury to pool or spa
users, installers, or others due to electrical shock, and may also cause damage
to property. Read and follow the specific instructions below.
Before installing or repairing this underwater light, read and follow all warning
notices and instructions accompanying this light and spare parts installation
manual. Failure to follow safety warnings and instructions can result in severe
injury, death, or property damage.
Visit www.zodiacpoolsystems.com for additional free copies of these instructions
or call Zodiac Technical Support at 800.822.7933 (U.S.) or 888.647.4004
(Canada)
Except when the Jandy Infinite WaterColors LED Lights are installed in an area
of the swimming pool that is not used for swimming and the lens is adequately
guarded to keep any person from contacting it, the light shall be installed in or on
a wall of the pool, with the top of the lens opening not less than 18 inches (457
mm) below the normal water level of the pool.
ATTENTION INSTALLER
This manual contains important information about the installation, repair,
operation and safe use of this product. This information should be given to the
owner/operator of this equipment.
The Jandy Infinite WaterColors LED Lights are intended for installation in
fresh water and salt water swimming pools. It is important to ensure that the
wet niches in which the lights are installed are intended for their appropriate
application, either fresh water or salt water pools.
Pool & Spa LED Lights | Spare Parts Installation Manual
™
WARNING
WARNING
CAUTION
NOTICE
Page 3