Publicité
Infinite WaterColors
Jandy
®
Risk of Electrical Shock or Electrocution. Always install a new lens gasket whenever
disassembling the light. Failure to do so may permit water to leak into the assembly,
which could cause:
(a) An electrical hazard resulting in death or serious injury to pool or spa users, installers,
or others due to electrical shock, or
(b) A malfunction of the Jandy Infinite WaterColors LED Light, which likewise could result
in serious injury to pool or spa users, installers, or bystanders, or in damage to property.
8.
Replace the old light lens gasket with the new gasket provided
with PCBA.
9.
Apply thermal paste to the back of the new PCBA.
10. Place the new PCBA into the pool light housing, ensure wires
pass through the top opening of the PCBA.
11. Install the green ground wire to the stud marked "Earth" and
tighten nut.
12. Install the PCBA nuts to the other studs.
13. Plug the blue connector terminal white wire to terminal N on the
new PCBA.
14. Plug the blue connector terminal black wire to terminal L on the
new PCBA.
15. Join the pool light assembly housing with the pool light lens
assembly, ensure the arrow on the lens is facing up.
16. Tighten the 8 screws on the back of the pool light in a star
pattern, see Figure 3.
Pool & Spa LED Lights | Spare Parts Installation Manual
™
WARNING
Page 7
Publicité
