Publicité
3.6.1 Starter cable LED indicator guide
LED
Stand by mode. The starter cable is
Green, flashing
connected to the product but no
battery is connected.
Jump start ready mode. The starter
Green, solid
cable is connected to the product and
the battery.
3.7 To use the lamp of the product
1
Push and hold the power button until the light turns
on with steady glow and then release the power
button. (Figure 2)
2
Push and release the power button to cycle through
the modes.
A.
Flash for SOS signal.
B.
Flash in strobe mode.
C.
Stop the lamp.
6
Troubleshooting
Problem
The display does not turn on.
The thermometer symbol flashes.
The product does not recharge.
The product starts, but will not jump start
the vehicle.
The green LED indicator of the starter
cable is lit but the engine of the vehicle
does not start.
Description
Possible cause
The internal battery is not charged.
The power button has not been pushed.
The product is too hot or too cold.
The power source is not live.
The charge level of the internal battery is
too low.
The temperature of the battery is too
low.
3
Recharge the product as soon as possible. Refer to
"3.2 To charge the internal battery of the product" on
page 9. .
4
Storage
● Charge the battery fully before storage.
● If the product is not in frequent use, charge the battery at
least once a month to prevent total discharge.
● Store the product at temperatures between –10–45°C.
● Store the product in a dry area out of direct sunlight.
● Store the product out of the reach of children.
5
Maintenance
5.1
To clean the product
● If needed, use a dry cloth to wipe all battery corrosion
and other dirt or oil from the battery clamps, cords, and
the outer case.
Do a check of the charge level of the
internal battery. Refer to "3.1 To do a
check of the charge level of the
internal battery" on page 9. If
needed, charge the internal battery
of the product. Refer to "3.2 To
charge the internal battery of the
product" on page 9.
Push the power button.
Wait until the thermometer symbol
will disappears.
Make sure that the charging cable is
connected correctly.
Make sure the charge level of the
internal battery is at least 50%. Refer
to "3.1 To do a check of the charge
level of the internal battery" on page
9.
Warm the battery. Refer to "3.6 To
warm up the battery of the vehicle"
on page 10.
Action
11
Publicité
