Publicité
Parts
Half a month
Process
Air
and
Clean
Regenerative
Air
replace if dirty.
Filters
Check whether there is
Process
air
and
mechanical damage, clean
regenerative air fans
the casing of motor and
fan as required
Check whether the driving
Wheel drive motor
belt
assembly
whether the installation is
appropriate.
Check
components and wiring in
Electrical control box
the electrical cabinet is
and wiring
damaged and overheat.
Make sure there is no
loose connection
Clean dust and debris in
Regenerative heater
the bottom and surface of
and rear heater
the heater.
Check whether there is
overheat and block or not.
Desiccant wheel
Clean dust in the surface
of wheel
Check whether there is
damage or shift. If there is
Hermetical seal
wear or damage, replace
it.
Check whether the air is
The connection of
leakage
unit and air duct
whether the connection of
unit and air duct is
12 months
the
filter
box;
Clean the filter box; replace if dirty.
Dust and debris in the cooling groove on the surface of the motor
housing must be cleaned, check the block terminal of the motor to
ensure the wiring is not loose, check whether there is any damage
to the impeller of the fan. If there are any signs of corrosion,
please act immediately.
Check the air volume and adjust the air valve as required, please
refer to the commissioning section in the manual.
Check the wiring of the motor to ensure it is not loose. Check
is
damaged
and
whether the block terminal of the motor is damaged and
overheat.
whether
the
Inspect the components and wiring in the electrical cabinet for any
signs of damage or overheating. During normal operation, if a
component is always active or never activates, move or reset it
several times regularly to engage its coil and contacts. Ensure all
connections are secure, and clean any dust and debris from all
parts. Clean dust and debris in the heat sink of the electric cabinet.
Check all piping, wiring and control parts are loose or not. If it is
loose, fasten it. Clean dust and debris in the bottom and surface
of the heater.
Check whether there is overheat and block or not. Clean dust in
the surface of wheel.
Check whether there is damage or shift. If there is wear or
damage, replace it.
Check for air leaks and ensure that the connection between the
or not ， and
unit and the air duct is secure. Additionally, inspect for any dust
buildup and check for any signs of damage
EN
Inspection and maintain procedures
Publicité
