Tineco Floor one S5 Serie Mode D'emploi page 29

Dry Filter
Grasp recessed area on each side of the dry filter
and pull upward. Rinse under running water and
must be completely dry before recombining with
the lid of the DWT.
* A spare dry filter is provided with your
appliance for convenient replacement.
Fig.D-6
Brush Roller Self-cleaning
1.Place the appliance on the charging dock after
use, the sensor will auto-detect the level of dirt.
2.When you hear the voice prompt "please
begin self-cleaning cycle," press the self-
cleaning button and begin the process.
3.Once complete, you will hear the voice prompt
"self-cleaning completed, please clean the
Dirty Water Tank." At this point, the appliance
will begin charging.
Fig.D-7
Note:
• Ensure the charging dock is plugged in and the
battery level>10%.
• Before self-cleaning cycle, please clean
the DWT and ensure the water level in the
CWT>40%.
Brush Roller Cover
1.Squeeze latches on the cover and pull upward
to remove.
Fig.D-8
2.Rinse with water.
Fig.D-9
3.While replacing, always latch the brush cover
into place to avoid leakage.
Fig.D-10
Brush Roller
1.Remove the brush roller by grabbing the brush
roller tab and pulling out.
Fig.D-11
2.Use the cleaning tool to remove the hair and
debris wrapped around the roller and then
rinse the roller with water. Replace the brush
roller back into the accessory holder, and allow
it to dry completely before reinstalling.
Fig.D-12
3.Remove hair and debris from the brush roller
chamber and the opening with a tissue or a
damp cloth.
Fig.D-13
4.Replace the brush roller by inserting the brush
roller end into the right side of the holder, then
attach the roller tab to the magnetic buckle on
the left side to lock into place.
Fig.D-14
Note:
• A spare brush roller is provided with your
appliance for convenient replacement.
• To maintain optimal performance, replace the
brush roller every 6 months.
SCAN THE QR CODE BELOW TO
GET PRODUCT CARE VIDEOS.
TROUBLESHOOTING
Problem
The appliance does
not turn on
Weak suction
Brush roller tangled
indicator blinking
Voice prompt:
Please clean the brush
roller
WiFi indicator is off
27
Solution
Restart after cooling
down
Install the dry filter or
clean and allow it to
dry completely
Remove blockages
Follow the in-app
guide to connect to
WiFi