Publicité
The instrument is delivered with the battery already installed.
Because of the safety regulations and appropriate precautions when preparing lithium batteries for transportation, the instrument
is equipped with a battery which has to be turned on for the first and next use.
In order to turn on the battery you have to
pull the non-conductive divider sticking
out from the instrument front panel
As this is a first time use, start by fully charging the battery.
Before using the FTV500, you must choose the language in which you want it to display menus and messages.
Press the green PWR ON button to switch on the instrument
CHARGING THE BATTERY
When the battery is fully discharged, charging takes, with switched off device:
FTV500 INSTRUMENT: 8 hours approximately
REMOTE UNIT: 5 hours approximately
SELECTING THE LANGUAGE
FTV500 INSTRUMENT
Connect the jack of the power supply to the instrument. Connect
the power supply to the mains.
Red LED on:
Red LED off or blinking:
WARNING: the instrument does not charge the battery while it is
turned on.
REMOTE UNIT
Connect the USB jack of the remote unit to the power supply.
Connect the power supply to the mains.
Charging: BATTERY CHARGE button LED flashing if it is
pressed
charging the battery
battery charged
12
Publicité
