Triton TRA001 Instructions D'utilisation Et Consignes De Sécurité page 15

Accessing the baseplate screw threads
1. To mount the router in a third-party router table or a table of
your own construction remove the 4 x screws of the baseplate
indicated in Image S and remove the baseplate.
2. There are 2 sets of screw threads as shown in fig. II. There are
4 x ¼ UNC screw threads (A) which are used to secure the
baseplate as well as suitable for table mounting plus an
alternate set of 3 x M6 threads (B).
Note: The M6 threads are not available on earlier versions of the
TRA001 router.
Accessories
• A wide range of suitable accessories for this tool are a
vailable from your Triton stockist, including a large selection
of cutter/router bits.
• Spare parts including carbon brushes, guide bushes
and collets are available from your Triton stockist or
www.toolsparesonline.com.
Maintenance
WARNING: ALWAYS disconnect from the mains power supply,
before carrying out any maintenance/cleaning of the charger.
General Inspection
• Regularly check that all the fixing screws are tight.
• Inspect the supply cord of the tool, prior to each use, for damage
or wear. Repairs should be carried out by an authorised Triton
service centre. This advice also applies to extension cords used
with this tool.
Cleaning
WARNING: ALWAYS wear protective equipment including eye
protection and gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause
internal parts to wear quickly, and shorten the device's
service life.
• Clean the body of your machine with a soft brush, or dry cloth.
• Never use caustic agents to clean plastic parts. If dry cleaning
is not sufficient, a mild detergent on a damp cloth is
recommended.
• Water must never come into contact with the tool.
• Ensure the tool is thoroughly dry before using it.
• If available, use clean, dry, compressed air to blow through the
ventilation holes (where applicable).
Lubrication
• Slightly lubricate all moving parts at regular intervals with a
suitable spray lubricant.
Brushes
• Over time the carbon brushes inside the Motor (6) may
become worn.
• Excessively worn brushes may cause loss of power, intermittent
failure, or visible sparking.
• To replace the brushes, remove the two Brush Access Covers (9).
Carefully remove the worn brushes (Image R) and ensure the
sockets are clean. Carefully replace with new brushes and then
replace the Brush Access Covers.
• After fitting run the router without load for 2-3 minutes to help
the brushes bed in. The process of the brushes fully bedding
in may take repeated uses. Motor sparking may continue until
new carbon brushes have bedded in.
• Alternatively, have the machine serviced at an authorised
service centre.
Contact
For technical or repair service advice, please contact the helpline
(toll free) on: 855-227-3478
Web: www.tritontools.com
Address:
Longleaf Distribution
85 North Street
Piedmont
AL 36272
USA
Storage
• Store this tool carefully in a secure, dry place out of the reach
of children.
Disposal
Always adhere to national regulations when disposing of power
tools that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste.
• Contact your local waste disposal authority for information on
the correct way to dispose of power tools.
EN
15