Publicité
Switching off the heater:
To shut down the heater, press the POWER
Let the heater cool down before unplugging it or restarting it.
To switch off the heater completely, push the side power switch, and then to unplug the supply cord
from the power supply.
Note: The heater will take some time to cool down after the power is shut off. Always wait until
it has cooled before moving it.
Safety Cut Off
The heater includes three safety protection.
Thermostat:
When encountering overheating, the heater automatically transitions to low gear heating and resets
once the temperature returns to a normal level following a brief cooling period. If overheating or
malfunctions persist, please reach out to our after-sales service centre to schedule an examination
of the product.
Automatic thermal cut-off:
This system switches off the heater in the event of overheating or malfunction. it cannot recover.
Please contact our after-sales service centre and arrange an examination of the product or get the
automatic thermal cut-off replaced.
Tip Over switch:
This technology switches off the heater if it is knocked over or tilted to a position where safe
operation is in jeopardy. Should this happen, place the heater upright again but take care as it will
still be hot. Once the heater is restored to an upright position, the heater will reset to work.
Maintenance and Cleaning
•
Switch the heater off, unplug it from the wall socket and let it cool before cleaning it and putting
it away.
•
Allow the appliance to cool down completely before cleaning.
•
Clean the heater using a slightly moistened cloth. Use only mild cleaning agents.
•
Do not use any cleaning chemicals such as detergents and abrasives.
•
Don't allow water to seep into the openings or come in contact with electrical connections.
•
To store away the heater, wind the cable round and store it in a clean and dry location.
Useful suggestion for the temperature setting:
This heater is classified as space heating radiator and there is no auxiliary device to let the heating
air ventilating fast. The heating element is located in the bottom of the heater, so it radiates slowly.
When in use, there will be a bit deviation between the value sensed by the built-in temperature
detector and the actual room temperature value. The following suggestions can be followed for
better heating effective:
1 - When use, it is recommended to set temperature value +8 °C higher than your room
temperature, the heating effective will be in high level.
button to enter standby mode.
7
English -
Publicité
