Publicité
4. Timer
A. To set the '24-hour turn-off timer' while the heater is on, press
flash, then press
time by one hour – the setting will be saved after three seconds of no action. The
icon will be displayed. The timer can be set between 0-24 hours.
B. To set the '24-hour turn-on timer' while the heater is in standby mode, press
The
icon will flash – use
or decrease the timer by one hour – the setting will be saved after three seconds of
no action. The
can also set the temperature and power output for the turn-on timer. If you want to
cancel the turn-on timer, press
5. Anti-frost function
A. If the heater is on standby and the room temperature is lower than 5℃, it will start
heating automatically. The
B. When the room temperature reaches 10℃, the appliance will stop heating.
C. If there is a fault with the temperature sensor, the display will show 'E2'.
Maintenance
1) Before cleaning, unplug the heater and wait for it to cool down completely.
2) Regularly wipe the heater with a damp cloth. Ensure the surface is dry before turning
on the heater again.
3) Clean the heater at least once a month during the heating season.
CAUTION! The heater should never be immersed in water.
Avoid using detergents to clean the heater.
Never let any water get inside the heater; this can be hazardous.
4) Remove dust and other debris with a soft cloth.
5) When not in use, store the heater in a dry and clean place.
Waste disposal
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or
retailer for recycling advise.
or
to set the timer. Each press will increase or decrease
or
will be displayed. The timer can be set between 0-24 hours. You
and the heater will turn on directly.
icon will be displayed.
to set the timer. Each press will increase
. The icon will
.
Publicité
