Publicité
On/off button
Increase button
Operation
1. Turn on:
To use the heater, plug it in and switch it on. Once you hear a beep, the heater will
enter standby mode and display the
the display will show the room temperature.
2. Temperature setting:
A. Temperature setting range is 5-50℃.
B. Default temperature setting is 25℃.
C. To set the temperature, press
icon will flash – the temperature will increase or decrease by 1℃ with each press. If
there is no action after three seconds, the temperature setting will be saved. After
setting the temperature, the current room temperature will be displayed.
D. The appliance will stop heating if the room temperature is 1℃ higher than the set
temperature. It will start heating if the room temperature is 2℃ lower than the set
temperature.
3. Power setting:
To adjust the power of the heater:
- Press
once for low power output (800W). The '01' icon will be displayed.
- Press
again for medium power output (1200W). The '02' icon will be displayed.
- Press
once more for high power output (2000W). The '03' icon will be displayed.
The default setting is the low power output (800W).
Operating instructions
Control panel
Power select button
Decrease button
or
Remote controller
Timer
icon. To turn on the heater, press
. When pressing either button, the
Turn on timer button
and
Publicité
