LUCCI Air AIRFUSION CLIMATE II Mode D'emploi page 8

Airfusion Climate II Installation Instructions
INSTALLING THE CANOPY COVER

Loosen 2 screws from the bottom of the mounting bracket.

Slide the canopy up to the mounting bracket and place the key hole on the canopy over the screw on the
mounting bracket, turn the canopy until it locks in place at the narrow section of the key holes and secure it by
tightening the two set screws. Avoid damaging the electrical wiring prepared previously.

Attach the canopy cover to the canopy and secure it by pushing the lugs into the holes.
BLADE INSTALLATION

Insert the blade screws (4) through the blade assembly in the following order, bracket kit (3), blade (2) and fiber (5).
Attach the blade assembly to the motor (1) and secure it by tightening the 2 screws (4). Fig. 8.

Repeat to install the other blades.

Finally install the bottom cover to the shaft of the motor by rotating it clockwise. Fig.9.
Fig. 8
7 | P a g e
Fig. 7
Fig. 9