iQ Pet No Bark Collar Guide D'utilisation page 13

- When the iQ No Bark collar is first activated by the dog's bark, the unit will
give a warning non-stimulating vibration. If the dog continues to bark, the
unit will give a non-stimulating vibration followed by a correction at the
level it is set on.
* The iQ No Bark Collar has a preset delay of 15 seconds in-between
corrections. Once the unit activates, it WILL NOT activate again until
15 seconds has gone by (The unit will reset to the warning non-stimulating
vibration after 17 seconds of a correction if the dog does not bark.).
TESTING THE IQ NO BARK COLLAR
- Turn the On/Off and Intensity Dial to (T), for the test mode. The LED
indicator will flash once, and after 2 seconds it will continue flashing every
2 seconds.
- Activate the collar by making sounds directly into the mic. The unit should
now vibrate twice. After waiting 15 seconds, repeat the test once more to
verify that it is fully functional.
* When on the test mode, the sensor may be sensitive enough that it may
activate easily by a quiet sound or tap.
ATTACHING THE COLLAR STRAP
1. With the On/Off
Intensity Dial going in
first, insert the body of
the iQ No Bark Collar
into the collar strap.
* For video instructions on how to attach the collar strap, please visit
www.iqpetcollar.com
12
Pull the strap around the body
of the iQ No Bark Collar in the
direction shown.
Hold strap here
2. Pull the collar strap
from the opposite side
of the On/Off Intensity
Dial over the rest of the
body.
Hold strap here
3. Be sure that the collar
strap is wrapped fully
around the body of the
iQ No Bark Collar.