Publicité
Note: Always place top
edge against fence
Inside Corner -
Left end
Use the left end of the cut
Right end
Use the right end of the cut
Outside Corner -
Left end
Use the left end of the cut
Right end
Use the right end of the cut
Inside
Corner
56
2610070552 _GCM18V-12GDC_20240712.indd 56
2610070552 _GCM18V-12GDC_20240712.indd 56
Saw Operations
Miter and Bevel Settings for Standard Crown Molding Cuts
(With Molding Flat on Table)
Assumptions: Molding is milled consistently. Corner is exactly 90°.
Molding Spring Angle 38°
Miter (Table)
Setting
31.6° Right
31.6° Left
31.6° Left
31.6° Right
Outside
Corner
Ceiling
52°
38°
38/52° Crown
Molding
38° Spring Angle
Molding Spring Angle 45°
Bevel (Tilt)
Miter (Table)
Setting
Setting
33.9° Left
35.3° Right
33.9° Right
35.3° Left
33.9° Right
35.3° Left
33.9° Left
35.3° Right
Fence
Top of Molding
Against Fence
Table
Ceiling
45°
45°
45/45° Crown
Molding
45° Spring Angle
Bevel (Tilt)
Setting
30° Left
30° Right
30° Right
30° Left
8/27/2024 9:32:12 AM
8/27/2024 9:32:12 AM
Publicité
