Publicité
Combination Square
1. Position square and
draw a light line
3/4" (19mm) board with
straight top edge
2610070552 _GCM18V-12GDC_20240712.indd 17
2610070552 _GCM18V-12GDC_20240712.indd 17
Tools Needed For Assembly
6/4mm Hex Key
(supplied)
NOTE: A 6mm and a 4mm hex key can be
substituted for the supplied 6/4mm hex key.
Combination Square Must Be True -
Checking Combination Square
drawn line
#2 Phillips Screwdriver
2. Flip square (shown in
dotted position)
3. Check edge of flipped
square against the drawn
line. There should be no gap
or overlap at the bottom
end.
no gap or overlap
17
8/27/2024 9:31:53 AM
8/27/2024 9:31:53 AM
Publicité
