Publicité
3.13
TOP EXIT
FAILURE TO INSTALL THE COVER PLATE AND GASKET WILL CAUSE THE APPLIANCE TO
FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
NOTE: This appliance has been factory shipped as a rear vent.
Remove the safety screen and glass front, refer to " SAFETY SCREEN / DOOR REMOVAL AND
A.
INSTALLATION" section.
Remove the contents from the firebox and set aside,
B.
you will need the exhaust collar from the top of the log
carton.
To ease assembly, remove the four hex head screws
C.
securing the deflector from inside the top front of the
FLUE PIPE
firebox.
WITH GASKET
Remove the single screw from the outer cover on the
D.
back of the appliance.
Remove the four screws on the 7" (178mm) intake
E.
collar assembly; set the intake collar and gasket aside.
Careful not to damage gasket.
Remove the single screw from the outer cover with
F.
knockout intact, on the top of the appliance and set
aside.
Remove the inner cover plate and gasket by removing
G.
the four screws. Reinstall the inner cover plate and
gasket onto the back of the appliance.
Take the outer cover (with knockout intact) and secure
H.
onto the back of the appliance.
Remove and discard the 1 1/2" thick batt of insulation
I.
from the top opening.
Place the 7" (178mm) intake collar
J.
and gasket onto the top of the
appliance and secure with the four
screws.
Reinstall the outer cover (without
K.
knock out) over the 7" (178mm)
exhaust collar assembly and secure.
From inside the firebox, install the 4"
L.
(102mm) exhaust collar up through the top of the firebox and secure with the the four hex head 3/8"
thread cutting screws. NOTE: Do not overtighten. The gasket needs only to be snug against the
firebox.
M.
Reattach the top deflector, log set, glass door and safety screen.
WITH GASKET
FLUE PIPE
WITH GASKET
TO TOP VENT
TO TOP VENT
FLUE PIPE
WITH GASKET
FLUE PIPE
WARNING
!
DEFLECTOR
DÉFLECTEUR
F
I
OUTER
F
COVER
(with knockout)
I
E
GASKET
INTAKE COLLAR
ASSEMBLY
OUTER COVER
E
GASKET
INTAKE COLLAR
ASSEMBLY
OUTER COVER
INNER
COVERPLATE
G
OUTER
COVER
(with knockout)
EXHAUST FLUE COLLAR
INNER
COVERPLATE
G
W415-1398 / C / 06.15.17
25
EN
E
D
E
D
GASKET
GASKET
Publicité
