Publicité
! Always unplug the power tool before cleaning and
maintenance.
There are no parts in the tool that you can repair.
Never use water or chemical cleaners to clean your
tools. Wipe it with a dry cloth.
Keep the motor fan grill clean.
If you see a very faint spark in the engine compart-
ment, your tool is fine. If there is increased sparking,
this is a fault with the engine.
Never clean any part of the tool with a hard, sharp or
rough object.
It is advisable to use compressed air to remove dust.
Regularly check the carbons (cleanliness and wear).
Dirty or worn carbons cause excessive sparking and
reduced power / speed.
Gear Lubrication (J)
! Always make sure there is enough grease in the
gear before using the tool.
Check the condition of the lubricant at least every 5
hours of operation.
Using the supplied key, open the transmission part by
removing the lubrication hole cover (4).
If necessary, top up the lubricant - with the supplied
product or an identical one. Use a plastic grease
for bearings or gears, eg NH3. Do not use graphite
grease!
Put the cover (4) back in place and tighten with the
wrench.
Storage when not in use for a long time
Do not store the tool in a place where the temperature
is high.
If possible, store tools in a place with constant
temperature and humidity.
SPECIFICATIONS
Input voltage 230 V
Input frequency 50 Hz
Power consumption 1800W
Idle speed 0-820 min-1
Impact frequency 4000 min-1
Weight 5.2 kg
Maximum borehole diameter:
concrete 36 mm
steel 13 mm
wood 42 mm
SDS-plus chuck (10 mm)
impact force: 7.0J
Protection class / II.
Sound pressure level measured according to EN
60745:
LpA (sound pressure) 94 dB (A) KpA=3
LWA (acoustic power) 105 dB (A) KwA=3
Take appropriate measures to protect your hearing!
Use hearing protection whenever the sound pressure
level exceeds 80 dB (A).
Weighted effective acceleration value according to
EN 60745: 14.76 m/s2 K=1.5
Caution: The vibration level may vary during power
tool operation from the declared value depending on
the way the power tool is used and depending on
the following conditions: Method of power tool use
and type of material being cut or drilled, conditions
of the power tool and method of its maintenance,
appropriateness of the used accessories and ensur-
ing its sharpness and good conditions, the strength
of handle gripping, use of anti-vibration equipment,
suitability of the power tool for the purpose for which
it has been designed and compliance with workflows
according to manufacturer's instructions.
If this power tool is used in an inappropriate manner,
a hand/shoulder vibration syndrome may appear.
Caution: For clarification, it is necessary to consider
the level of vibrations in specific conditions of use in
all operating modes, e.g. the time when the power
tool is switched off except for the operation time,
and when it idles, i.e. performs no work. This may
substantially decrease the exposition level during the
whole operating cycle.
Minimize the risk of vibrations, use sharp chisels, drill
and blades.
Keepthe power toolin compliancewith theseinstruc-
tions and provide for its proper lubrication.
When using the power tool regularly, invest into anti-
vibration equipment.
Do not use the power tool under temperatures lower
than 10°C. Plan your project containing work with the
power tool producing high vibrations carefully and
spread it over more days.
Subject to changes.
ENVIRONMENTAL PROTECTIONWASTE
MANAGEMENT
Power tools, accessories and packaging should
be provided for recycling and not to harm the
environment.
Do not dispose of power tools into household waste!
According to Directive 2012/19/EU of the European
42
Publicité
