Télécharger Imprimer la page

Aosom 440-026 Mode D'emploi page 11

Publicité

Install steel connector onto bike axle. Insert safety pin and pass safety strap though
chain stay pipe of bike.
CAUTION!
The height of the hitch clamp shall not exceed 15.5" (400 mm) above a road surface
and the standard drawbar load shall be between 30N and 80N. The hitch arm must
not bear any extra load.
WARNINGS!
Ensure the safety pin is secured with the spring clip. Please ensure your bike is completely
compatible with the trailer. The safety strap must be in place before use.
If the hitch arm interferes with your bike or other bike attachments, or if it does not tighten
securely, do not use. Contact your bike dealer for help with proper installation.
ATTACHING AND REMOVING STROLLER CONVERSION KIT
The stroller conversion kit consists of a push bar and front wheel assembly that
attach on the trailer to convert it for walking use.
Install the push bar by inserting ends into frame and pushing down until locking
devices snap into place. Insert the front wheel assembly into the bracket and firmly
tighten the knob.
To convert back to use as a trailer, loosen wheel bracket knob and remove the wheel.
To disassemble follow the instructions in the reverse order.
11

Publicité

loading

Produits Connexes pour Aosom 440-026

Ce manuel est également adapté pour:

440-026v01