Publicité
Status
C: Multi-purpose LED flashes green/red
D: Multi-purpose LED shows red
D: Multi-purpose LED quick-flashes green/red
3
Sanding head
The sanding head is 180° flexible, enabling the operator to reach the surface to be sanded from different angles. The power tool can track the
operator's movements, so the operator can adopt an ergonomic working position.
Items supplied
Random orbital sander, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at: www.hilti.group
Technical data
For rated voltage, rated current, frequency and/or input power, refer to the country-specific type identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be at least twice the rated input power
shown on the rating plate of the device. The operating voltage of the transformer or generator must always be within +5 % and -15 % of the
rated voltage of the device.
Weight in accordance with EPTA procedure 01
Speed
Eccentric stroke
Diameter, backing pad
Use of extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged while working. Disconnect the supply
cord plug from the power outlet.
▶
Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if found to be damaged.
•
Use only extension cords of a type approved for the application and with conductors of adequate gauge (cross section). The power tool
may otherwise suffer a drop in performance and the extension cord may overheat.
•
Check the extension cord for damage at regular intervals.
•
Replace damaged extension cords.
•
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
Information on recommended minimum conductor cross-sections and cable lengths is accessible via a link, in the form of a QR code,
at the end of this document.
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶
Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Positioning the sanding pad
Power tool, sanding pad and backing pad together form a system. Be sure to use the correct combination and settings for the application.
The choice of sanding pad (grit size), speed and contact pressure determines the stock removal rate and the finish.
1. Unplug the supply cord from the power outlet.
2. Select a suitable sanding pad and secure it to the backing pad. Make sure that the sanding pad is centered and securely seated against the
backing pad.
Operation
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while work is in progress, immediately disconnect
the device and the cord from the electricity supply. Do not touch the damaged part of the cord.
▶
Regularly check all supply cords. Replace defective extension cords. Have damaged power cords replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of 30 mA is recommended.
*2301587*
2301587
Meaning
Speed is increased/reduced; selected speed is indicated by the
LEDs.
Overtemperature warning.
Voltage outside appropriate range.
DWS 225
3.5 kg
4,000 /min ... 8,000 /min
(66.7 Hz ... 133.3 Hz)
5 mm
225 mm
4
Publicité
