Publicité
Switching between metric and imperial units
Press memory buttons ❶ ❷ and ❹ for 5 seconds.
The handset display will show "C-I".
c - i
1
2
3
4
For metric: Press ❷, the handset display will show "C" for centimeters.
For imperial: Press ❸, the handset display will show "I" for inches.
Note: Imperial units (inches) are the default UOM.
Setting up parallel connectivity
A Y-splitter cable is required to parallel connect two UPMOD-2LV frames
to adjust as one.
Make sure both desks are adjusted to the lowest position.
Plug both "male" ends of the Y-splitter cable into the H port of both
control boxes.
Plug the "male" end of the handset cable into the "female" end of the
Y-splitter cable.
Synchronize all 4 legs together – press and hold
The control boxes will beep twice to notify you that they are now
parallel connected.
Troubleshooting
This guide is to provide general instructions to troubleshoot your
upCentric
height adjustable table.
®
WARNING
Ensure the desk is free to move and not obstructed.
Personnel should use caution to prevent injury from a desk in motion.
Please note this is a general guide and not absolute.
14
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
and
buttons together.
Synchronize table legs
Prior to performing any troubleshooting, perform a re-synchronization.
On occasion, the table may require a re-sync for a variety of reasons.
This is normal.
•
Ensure there are no obstructions for the desk to move vertically.
•
Press and hold
and
at the same time.
•
Continue to hold
and
until it reaches the bottom ( lowest point ).
•
Release the buttons once the system beeps.
•
If it does not beep, or if the desk is not level,
repeat the re-sync operation.
•
This operation may be required a few times
until the desk is at the lowest level position.
The system has now been re-synchronized.
E00
E01
E02
E03
E04
E11
E12
E13
E21
E22
E23
E31
E32
E33
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
while the desk lowers
Error codes
Synchronization in progress
Overuse protection
Unbalance protection
Anti-collision
T-touch protection
M1 motor over-current protection
M2 motor over-current protection
M3 motor over-current protection
No Hall sensor from M1
No Hall sensor from M2
No Hall sensor from M3
No current from M1
No current from M2
No current from M3
15
Publicité
