Publicité
Assembly instructions
Preparing the tabletop
Step 1: Lay protective matting / sheet on floor or work surface
to protect the tabletop surface.
Step 2: Carefully place tabletop down on work surface with
the decorative laminate facing down and brown surface facing up.
Assembling your table
Step 1: Place the table leg housing ( I ) on a flat surface, and insert leg ( K )
into the table leg housing. Fasten table leg housing to table leg
using 4 x bolts ( B ) starting with the two holes closest to the back
of the bracket. Repeat for second column.
Step 2: Align the table leg housings to
the pilot holes on your tabletop.
Secure table leg housings in place
using screws ( C ) – 8 per leg housing.
NOTE: If your tabletop does not
have pilot holes, simply position
the table leg housings so they are
0.5"- 1" from each edge, centered
from front to back.
8
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
Retrofitting onto existing work surface
0.5"- 1"
First
Second
Step 3: Align handset ( H ) along the front edge of
the tabletop, 1"- 3" from the desired corner,
and attach handset to the tabletop with
2 x screws ( D ).
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
0.5"- 1"
9
Publicité
