Publicité
Customizable digital display settings
There are two changeable options for the digital height readout on the
digital display handset:
1. Changing desk starting height
The default starting height on the digital height readout is 22.9",
which is the accurate minimum table height for this table when using
a 1" thick work surface and standard glides; however, if you add casters
or retrofit the table frame onto a tabletop that is thicker or thinner
than 1" the starting height may be higher or lower than 22.9".
In these cases, the digital height readout can be adjusted so that
the starting height is accurate to the actual lowest height of the
work surface. See page 13 for instructions.
2. Converting between metric and imperial measurements
The default unit of measure ( UOM ) displayed on the digital height
readout is inches; however, you can change between inches and
centimetres for your desired UOM. See page 14 for instructions.
Gyro-sensor anti-collision system
Every upCentric
electric height adjustable table has a built in gyro-sensor
®
based anti-collision system. This patented anti-collision system uses precision
gyroscope technology, allowing for three axis collision detection.
This sensor provides enhanced safety to help prevent user injury and
equipment damage. When the table is in motion, if it encounters any
external resistance or unbalance in the tabletop, the gyro-sensor picks up
the disturbance immediately and enacts a safety stop.
The table will stop moving immediately and reverse adjustment by 1" to
move away from the obstruction is has come in contact with.
Power-saving and quick start wake-up
upCentric electric height adjustable tables have the lowest power draw of
any electric height adjustable table on the market. When no buttons have
been pressed for 30 seconds, the control box goes into stand-by mode,
where the control box uses less than 0.1 W of electricity.
When in sleep mode, press any button to wake the system up.
The quick start feature allows the table to start moving immediately once
a button has been pressed, with no wake-up delay.
4
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
Parallel connectivity
UPMOD - 2LV is equipped with parallel connectivity.
The upCentric
®
This feature allows you to connect two tables together and operate them
as one table. A Y-splitter cable is required to enable this.
Important information
•
Always make sure all screws are tightened before
use of the table and after moving or transporting.
•
Duty cycle of the frame for desk is 10 %,
max. 2 minutes operating / min. 18 minutes stop.
•
Ensure the loading on each leg is less than the maximum
outlined below, otherwise it might cause permanent damage
to the leg (s) during operation.
Table maximum
Each leg maximum
•
When the motor cable is connected to the control box, the legs
can maintain an adequate locking force up to the maximum load on
the tabletop. However, when the cable is damaged or is disconnected
from the control box, it will cause the desk to sink to the bottom within
hours if the load on either leg is larger than the maximum capacity.
•
Make sure that no persons or items will collide with the table,
when adjusting upwards and downwards.
•
Damaged cords must be replaced before connecting
the main power cable.
•
Keep at least 3/4" of free space around the whole frame / tabletop.
•
The upCentric
is not intended to be used as a person lift.
®
•
Do not pull or push the table if adjusting.
•
Do not lift the frame or table off of the ground when adjusting.
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
Load capacity
200 lbs ( 90.9 kg )
140 lbs ( 63.5 kg )
5
Publicité
