Publicité
Getting started
The first time a table is assembled, the legs must be synchronized before use.
OOO
1
2
3
4
How to synchronize
Press and hold the up/down buttons on the handset at the same time
for 3-5 seconds, both legs will begin to lower. Continue holding the buttons
until both legs reach the lowest position.
When finished synchronizing, the legs will stop moving and the handset will
make a beep sound and the buttons can be released. The display will show
the starting height.
How to set a memory position
Use the
and
buttons to adjust table to the desired height.
Hold the
button and the desired memory button ( ❶, ❷, ❸ or ❹ )
together until P1, P2, P3 or P4 is shown on the display screen.
Now you can press the memory button and the table will automatically
move to the preset memory position.
P2
1
2
3
4
How to set a maximum height limit
Move the table to the desired maximum height.
Press and hold the
button while simultaneously pressing
the
button 4 times.
A beeping sound will notify you that the process has completed.
Note: You must press the
and
press and you must continue to hold the
setting will not work.
12
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
button at the same time on the first
button the entire time, or this
How to disable a maximum height limit
Move the table to the maximum height limit.
Press and hold the
button while simultaneously pressing
the
button 4 times.
A beeping sound will notify you that the process has completed.
Note: You must press the
and
press and you must continue to hold the
setting will not work.
How to set a minimum height limit
Move the table to the desired minimum height limit.
Press and hold the
button while simultaneously pressing the
4 times. A beeping sound will notify you that the process has completed.
Note: You must press the
and
press and you must continue to hold the
setting will not work.
How to disable a minimum height limit
Move the table to the minimum height limit.
Press and hold the
button, while simultaneously pressing the
4 times. A beeping sound will notify you that the process has completed.
Note: You must press the
and
press and you must continue to hold the
setting will not work.
Adjusting your starting display height
First, make sure your table is adjusted to the lowest position.
Press and hold
for 5 seconds, the digital display will begin to flash.
Once flashing, use the
and
handset display.
Once the handset display is showing the correct height, wait 10 seconds.
The display will stop flashing to confirm that you have successfully set
the starting height.
upCentric
– UPMOD-2LV Owner's Manual | Guide de l'utilisateur
®
button at the same time on the first
button the entire time, or this
button at the same time on the first
button the entire time, or this
button at the same time on the first
button the entire time, or this
buttons to adjust the height on the
button
button
13
Publicité
