Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Operating Elements
1.
Torque Adjustment Collar
2.
Dual Range Gear Shifter
3.
Replaceable carbon brush
4.
Forward / Reverse Control Button
5.
Soft Grip
6.
Accumulator
7.
Variable Speed Switch
6. Operation
a) Charging the accumulator
Observe all safety instructions contained in these operating instructions without fail, chapter 4. c) in particular.
Before operating the product for the first time, the accumulator safely installed in the cordless drill / screwdriver is to be charged.
Principally, the following rules apply: A new accumulator or an accumulator which has not been used for a longer period of time reaches
its full power only after 5 complete discharge and recharge processes.
When operating the cordless drill / screwdriver it has to be recharged:
•
if the drive only moves very slowly without any load
•
every 3 months if it is stored for long periods of time.
To charge the accumulator, place the accumulator in the accumulator compartment in the correct orientation.
The plug-in charging set does not turn off automatically, if the accumulator is completely charged!
Battery status indicators
Red LED is on
Green LED is blinking
Green LED is on
Green LED and Red LED are blinking
Red LED is blinking
b) Removing and inserting the accumulator
1.
To remove the accumulator, press the two lateral push buttons (A).
2.
Then, the accumulator can be pulled out downwards.
3.
To insert the accumulator, position it with correct the orientation at the bottom of the cordless screwdriver and push until it engages.
22
8.
Built-in LED light
9.
Keyless Chuck
10. Red LED light (Battery status indicator)
11. Green LED light (Battery status indicator)
12. Accumulator Compartment
13. Power Cord
Standby
Charging
Fully charged
The accumulator is too hot or too cold. (Charging will begin automatically when the accumulator
reaches the correct charging temperature.)
The accumulator is not functioning.
A
Publicité
Chapitres
Table des Matières
Dépannage
