Maintenance And Cleaning - TOOLCRAFT DD10,8VLI Notice D'emploi

8. Maintenance and cleaning

A thorough cleaning maintains the operability of the product so that you can enjoy it for a long period of time. A good craftsman is careful with
his tools!
a) Replacing the carbon brush
1. Unscrew the caps (C) on the lateral sides of the drill.
2. Remove the carbon brush from the brush holder.
3. Insert a new carbon brush.
4. Close the caps.
5. Run the tool for a few minutes for the brushes to adjust before next use.
b) Cleaning
Blow dirt and dust out of the air vents with dry air by running the motor. Wear safety glasses when performing this operation.
Clean the exterior plastic parts with a damp cloth and mild detergent. Do not use solvent to clean it although it is highly solvent resistant.
Clean the exterior of the charger with a cloth or a soft non-metallic brush. Do not use water or any cleaning solution to clean it.
Disconnect the charger from the AC power before cleaning the charger.
Ensure that liquids do not enter into the interior of the device, because they could damage the product.
Improper cleaning agents can cause a discolouration at the plastic surface.
Never use aggressive scouring cleaners, alcohol, gasoline, spirit or similar liquids for cleaning the device!
After cleaning, allow the product to dry completely before operating it again! This applies particularly for the plug-in charging
set!
26
C