Accumulator And Charging Set - TOOLCRAFT DD10,8VLI Notice D'emploi

Take special care if you screw in long screws because they might jam or the cordless drill / screwdriver might slip down,
risk of injury!
Never subject the cordless drill / screwdriver to such a high load that the drive will stop.
When boring or screwing above your head, put on appropriate safety goggles. Your eyes might be injured by bore dust or
chips.
In some cases an additional breathing mask should be worn which protects your nose, mouth and lungs from dust, an ear
protection is recommended as well.
If boring or screwing above your head, do not use the magnetic holder on the top side of the cordless drill / screwdriver. The
screws at this holder could fall down (e.g. into your face/eyes), risk of injury!
Hold the cordless drill / screwdriver safely. In case of a sudden stop of the drive (for example, if a drill is interlocked) the
torque is transmitted to the cordless drill / screwdriver itself, it distorts laterally. Due to this, the cordless drill / screwdriver
might fall out of your hand, risk of injury!
Never look directly or with optical instruments into the light beam.
Never point the light beam at mirrors or other reflecting surfaces.
Never point the light beam at people or animals. This can lead to eye or skin injuries.
As much as is possible, direct the light beam so that it is not at eye level.
c) Accumulator and charging set
To charge, the rechargeable battery must be removed from the cordless screwdriver and may only be charged using the
charging station included in delivery. Use the plugin charging set exclusively for the cordless drill / screwdriver!
Only charge the accumulator at an ambient temperature of about 10°C to 30°C.
If the cordless accumulator has warmed up in longer periods of operation, allow it to cool down before charging it.
Only recharge the accumulator if it is completely discharged. If an accumulator not being totally discharged is recharged
several times subsequently or if it is recharged after a short period of operation, the operating life of the accumulator will be
reduced and capacity losses will be caused (memory effect).
The Li-ion accumulator used will discharge itself slowly, if it is not used (so called self-discharge). If you do not use the
cordless drill / screwdriver for a longer period of time, recharge the accumulator at regular intervals, approximately every
3 months.
Protect the product against strong coldness, heat or direct sunlight. Contrary ambient conditions can not only reduce the
operating life of the accumulator but also cause risk of explosion or of destruction of the accumulator in extreme cases.
Do not throw the cordless drill / screwdriver with the accumulator installed into fire, risk of explosion can be caused by the
accumulator!
Handle the product carefully, ensure that the cordless drill / screwdriver and plugin charging set do not fall down. Due to the
heavy weight of the product, there is not only the risk of destroying it but also risk of injury.
Never take the accumulator apart.
Short circuits of the contacts of the accumulator can cause risks of fire and explosion!
21