Publicité
CLEANING THE DUST BIN FILTER
The Dust Bin Filter consists of a HEPA Filter and Sponge Filter.
Clean both the HEPA and Sponge fi lters as per the following sequence.
1. Pull the hook on the left of the HEPA Filter
module on the rear side of Dust Bin to separate
the HEPA Filter and the sponge.
2. Thoroughly clean out the fi ne dust particles on the
HEPA Filter, with a vacuum cleaner or cleaning brush.
※ Do NOT wash the HEPA Filter with water.
Its suction power will be reduced.
3. Use a cleaning brush to clean the Sponge Filter.
If using water to clean it, allow it to dry completely
in the shade before refi tting.
4. Assemble the HEPA and Sponge fi lters back onto
the Filter Cover as per the following sequence.
※ Fit the rectangular locator on the HEPA Filter
into the locating slot of the fi lter body.
※ Be careful not to incorrectly assemble HEPA
and Sponge Filter onto the Filter Cover.
Tip
• To preserve the performance of Robot Cleaner, clean the HEPA Filter at least once a week,
with a brush or vacuum cleaner.
• If you run Robot Cleaner, with the Filter Cover assembled onto Dust Bin and without no filters
inserted, it may involve dusts coming inside to cause a failure.
30
Publicité
