Publicité
If the dust bin is full, suction power can be reduced. Clean the dust bin before and after each cleaning
session. Clean the dust bin using the following sequence:
1. Open the dust bin cover by pressing the PUSH
button on the Robot Cleaner.
2. Grab the handle of the dust bin and pull it
upward.
3. Pull the hook on the left of Filter Cover on the
rear of Dust Bin to separate the fi lter and the
sponge.
※ Note that separating the fi lter may result in
dust dropping.
※ Refer to p.30 when cleaning the Dust Bin Filter.
4. Lift the cover upward while pressing the
separation button on the dust bin.
5. Empty the dust bin and clean it with a cleaning
brush or under running water.
6. After cleaning with water, completely dry the
dust bin in a well-ventilated area out of the direct
sunlight.
7. When reassembling or fi tting the cleaned Dust
Bin, close the cover and put in the Sponge and
HEPA Filter.
※ Refer to p.30 for detailed assembly guides.
8. Put the dust bin into the Robot Cleaner and close
the dust bin cover.
Tip
• Operating the unit without Filters fitted to the dust bin can cause a motor malfunction not
covered by warranty.
• After cleaning the Dust Bin, make sure to assemble the filter and fit it to the Dust Bin.
If you initiate cleaning, with no filters fitted to the dust bin or Filter Cover not assembled,
a voice message will be announced which says "Please check that the dust bin and filter are
properly installed."
• Always ensure that the dust bin cover is refitted correctly after
cleaning the dust bin so that it closes easily and accurately.
CLEANING THE DUST BIN
29
Publicité
